Enmet EX-5130 User Manual

ENMET Corporation PO Box 979 Ann Arbor, MI 48106-0979 www.enmet.com Manual Part Number 80003-093 MCN-13-011, 12/20/13

EX-5130-IS ENMET Corporation 8 5.2 Calibration of the EX-5130-IS Calibration is the process of setting the instrument up to read accurately when

EX-5130-IS ENMET Corporation 9 5.2.1 Zero Adjust A ZERO function should be performed only when the EX-5130-IS sensor/transmitter is exposed to fr

EX-5130-IS ENMET Corporation 10 Normal Display Mode 5ppm MENU HOLD the magnet over the MENU switch for 2 – 4 seconds to enter the Maintena

EX-5130-IS ENMET Corporation 11 5.3 Sensor Replacement CAUTION: Area must be declassified during sensor replacement. Sensors should be replaced w

EX-5130-IS ENMET Corporation 12 6.0 Replacement Part Numbers ENMET replacement part numbers: Description Part Number For EX-5130-IS p/n Sensor:

PO Box 979 680 Fairfield Court Ann Arbor, Michigan 48106-0979 734.761.1270 Fax 734.761.3220 Returning an Instrument for Repair ENMET instru

Repair Return Form Mailing Address: ENMET Corporation PO Box 979 Ann Arbor, Michigan 48106 Phone Number: 734.761.1270 FAX Number: 734.76

Table of Contents 1.0 INTRODUCTION ...

EX-5130-IS ENMET Corporation 1 1.0 Introduction The ENMET EX-5130-IS sensor/transmitters (S/T) is a three wire 4-20mA S/T for the detection of t

EX-5130-IS ENMET Corporation 2 2.0 Features of the EX-5130-IS See Figure 1 for location of features: Feature Description Display LCD: Indicates

EX-5130-IS ENMET Corporation 3 3.0 Installation of the EX-5130-IS CAUTION: Area must be declassified during installation. The ENMET EX-5130-IS ga

EX-5130-IS ENMET Corporation 4 3.2 Wiring the EX-5130-IS to a Control Unit CAUTION: Area must be declassified during installation. Run conduit an

EX-5130-IS ENMET Corporation 5 4.0 Operation of the EX-5130-IS It is best to have the EX-5130-IS transmitters powered up and operational for 24 h

EX-5130-IS ENMET Corporation 6 4.2 Normal Display Mode When the EX-5130-IS is installed as described in section 3, and in clean air, the POWER gr

EX-5130-IS ENMET Corporation 7 5.0 Maintenance of the EX-5130-IS CAUTION: Do not open the EX-5130-IS S/T in a classified area. CAUTION: Do Not At