Enmet DC Powered Sample Module User Manual

ENMETENMET CorporationPO Box 979Ann Arbor, MI 48106-097980003-141February 1999MCN-248, 01/22/01MCN-291, 10/21/03Instruction ManualGas Sampling UnitDC

ENMET Corporation Gas Sampling Unit6Figure 5: Wiring Diagram Gas Sampling Unit with RX-1G ControlNOTE: On some installations, the 4-20mA signal may be

Gas Sampling Unit ENMET Corporation75.0 Operation5.0 OperationThe Gas Sampling Unit requires no calibration itself, however any sensor/transmitter or

ENMET Corporation Gas Sampling Unit8Figure 7: Venting Calibration Gas to a Gas BagFigure 8: Venting Calibration Gas to an Exhaust LineInlet PortOutlet

Gas Sampling Unit ENMET Corporation96.0 Maintenance6.0 MaintenanceThe flow rate of the sampling pump should be checked occasionally. The sampling pum

ENMET Corporation Gas Sampling Unit104. Remove diaphragm from armature by pulling itover the retaining screw.5. Replace diaphragm. –Wet new diaphra

Gas Sampling Unit ENMET Corporation116.2 Pump Maintenance for Pump 04018-118For the maintenance of ENMET part number 04018-118.Top View Side ViewFigur

ENMET Corporation Gas Sampling Unit126.2.2 Check Valve Housing ReplacementIf the check valve becomes damaged or to warn to operate correctly it can be

Gas Sampling Unit ENMET Corporation137.0 Warranty7.0 WarrantyENMET warrants new instruments to be free from defects in workmanship and material under

ENMET Corporation Gas Sampling Unit14Notes:

PO Box 979680 Fairfield CourtAnn Arbor, Michigan 48106-0979734.761.1270 Fax 734.761.3220Returning an Instrument for RepairENMET instruments may be ret

Repair Return FormMailing Address:ENMET CorporationPO Box 979Ann Arbor, Michigan 48106Phone Number: 734.761.1270FAX Number: 734.761.3220Shipping Addr

Table of Contents1.0 INTRODUCTION...

Gas Sampling Unit ENMET Corporation11.0 Introduction1.0 IntroductionThe ENMET gas sampling unit is used in applications requiring air sample draw to a

ENMET Corporation Gas Sampling Unit22.0 Specifications2.0 SpecificationsPower Requirement 10 - 30 VDCSuction Flow Rate 0.3 Liter/min. (adjustable afte

Gas Sampling Unit ENMET Corporation3Internal ViewExternal ViewFigure 1: Gas Sampling Unit FeaturesEnclosureNEMA-4X(Optional)Exhaust OutletSample Inlet

ENMET Corporation Gas Sampling Unit44.0 Installation4.0 InstallationThe Gas Sampling Unit needs to be level and as close to the area to be monitored a

Gas Sampling Unit ENMET Corporation5View of Internal PCB in ISA-MFigure 4: Application, Remote Sensor, Motorized Sample Draw SystemUsing 12 VDC source